Table of Contents
Advertisement
19
FUNCTIONS LINKED WITH A VEHICLE
Supported Models: Mobile
When the transceiver is installed in a vehicle, functions linking with a vehicle, such as Ignition Sense or Horn Alert, can be
used.
19.1
Turning the Transceiver ON or OFF by Linking with the
Ignition Sense Port Status (Ignition Sense)
Ignition Sense can be used to automatically turn the transceiver ON or OFF linked with the status of the Ignition Sense port
of a vehicle. While the vehicle engine is running, the Ignition Sense port should be in the high state and when the vehicle
engine is not running, the Ignition Sense port should be in the low state.
The transceiver is automatically turned ON when the Ignition Sense port goes high and is automatically turned OFF when
the port goes low.
Ignition Sense can be enabled or disabled using KPG-175D.
Note
To use Ignition Sense, the Ignition Sense cable (KCT-18) and the Ignition Line of the vehicle must be connected using the KCT-60.
Configuration using KPG-175D
Configuring the Ignition Sense to be enabled or disabled (
The Amount of Time until the Transceiver Is Turned OFF (Timed Power-off)
Timed Power-off is the amount of time from when the vehicle stops running (the status of the Ignition Sense port is low)
until the transceiver is automatically turned OFF.
If the amount of time configured for Timed Power-off elapses after the vehicle's engine stops running, the transceiver is
automatically turned OFF. This function is convenient for continuing communications even if the vehicle engine is not
running.
The Timed Power-off Pre-alert Tone sounds from the transceiver in the following way if anything other than "Off" is
configured for Warning Tone:
•
1 min before the transceiver is turned OFF: The transceiver beeps twice. (Timed Power-off Pre-alert Tone 1)
•
10 sec before the transceiver is turned OFF: The transceiver beeps 4 times. (Timed Power-off Pre-alert Tone 2)
•
2 sec before the transceiver is turned OFF: The transceiver beeps continuously.
(Timed Power-off Pre-alert Tone 3)
Note
Timed Power-off is reset if the Ignition Sense port goes high.
Configuration using KPG-175D
Configuring the Timed Power-off (
FUNC (K)/Ver 1.20
See
See
Edit > Extended Function > AUX > Ignition)
Edit > Extended Function > AUX > Ignition)
CONTENTS
INDEX
188
Advertisement
Table of Contents
