Nortel Meridian 1 Option 11C Upgrade Manual page 61

Upgrade a two-cabinet system with metal cable to Option 11C
27 Install the new NTAK11 cabinet on the wall (or pedestal).
To install the cabinet on a pedestal, first remove the door hinge
opening tabs on each side of the cabinet with a pair of pliers. See
Figure 20.
Figure 20
Door hinge opening
28 Connect a #6 AWG (40 Metric) ground wire from the ground lug in
the expansion cabinet to the grounding block installed in Step 8
on page 48.
29 Install a fiber routing guide under slot 0 (Fbr Rx), as shown in
Figure 12 on page 50.
Install the fiber routing guide in the cable connector area below the
circuit cards. Fasten the router with the existing screws below the card
slot.
30 Connect all the cables that you labeled and disconnected from
the old cabinet in Step 24 on page 60.
The connectors in the cabinet for cables going to the cross-connect
terminal are J1 to J10 (instead of J11 to J20). Connect the identified
cables as shown in Table 1.
Option 11C and 11C Mini
Page 61 of 224
Upgrade Procedures Guide