Nortel Meridian 1 Option 11C Upgrade Manual page 148

Page 148 of 224
553-3021-250 Standard 7.00
Option 11/11E upgrade from Software Daughterboard or PCMCIA
4 Observe the terminal screen.
One of the following two messages appears and the software
installation continues as indicated.
— If the message is
INSERT SOFTWARE DELIVERY CARD
continue with Step 5 on page 148.
— If the message is
INSTALL SETUP PROGRAM
go to Step 6 on page 149.
5 If you need to, install the software delivery card in the socket in
the faceplate of the SSC card.
Note: Skip this step unless you are using the software delivery
(PCMCIA) card to install the software.
To install the software delivery card:
a Insert the card in slot A in the PCMCIA socket located in the
faceplate of the NTDK20 Small System Controller (SSC) card.
b Carefully press on the software delivery card until it seats tightly.
Refer to Figure on page 149 for the correct position of the SSC
card.
April 2000