Nortel Meridian 1 Option 11C Upgrade Manual page 142

Page 142 of 224
553-3021-250 Standard 7.00
Assign TDS/DTR, XTD, and SDI functions
Note: Systems in North America normally use DTRs and allow the
card to operate as a standard DTMF receiver. This step only applies if
you are using a DTR. If you use an XTD instead, skip this step and
continue to Step 3 on page 142.
Table 21
LD 13 - Configure DTR units on card 0.
Prompt Response
REQ NEW
TYPE DTR
TN 0 u
3 Configure the XTD units on card 0, units 0 through 7 in LD 13 (see
Table 22). Make sure you configure all eight units. (Do not
perform this step if you are using DTR instead of XTD—you
completed the procedure in Step 2).
Note: Systems outside North America normally use XTDs. Do not
perform this step if you use a DTR instead of an XTD (see Step 2 on
page 141).
Table 22
LD 13 - Configure XTD units on card 0.
Prompt Response
REQ NEW
TYPE XTD
TN c u
XTDT (0)-7
_DTO (NO), YES
—————————— End of Procedure ——————————
April 2000
Comments
Add.
Define Digitone receivers.
Card 0, u = 0-7
Comments
Add information.
Extended Dial Tone Detector and
Digitone Receiver data block.
c = 0
u = 0 to 7 (Repeat until you
configure all eight units.)
Extended Tone Detector Table
Number. If you enter a table that
is not 0, it must exist in LD 97.
Dial Tone Detection only.
(NO) = Do not disable DTR
detection
YES = Disable DTR detection,
only perform dial tone detection