Nortel Meridian 1 Option 11C Upgrade Manual page 24

Page 24 of 224 Upgrade a single-cabinet system to Option 11C
553-3021-250 Standard 7.00
11 Connect the power to the cabinet.
Set the circuit breaker switch on the front of the power supply unit in
the cabinet to ON.
If equipped with reserve battery power, set the circuit breaker switch
on the reserve battery power unit to ON.
When you power up, the Software Installation Program starts
automatically.
Note: The Software Installation Program is menu-driven, allowing the
easy installation of software and customer databases in the Option
11C. It is clear and direct and includes a Help facility to help you make
correct selections. However, if you need more detailed information,
refer to the Option 11C Planning and Installation Guide
(553-3021-210) .
12 Install the new NTDK20 SSC card in the slot left empty by the
NTAK01 or NTBK45 card (Slot 0).
If a fiber-optic cable is present (see optional Step 10 on page 21),
make sure that it is in the fiber routing guide.
Note: Do not staple or twist fiber-optic cable. Do not bend it beyond a
minimum 35 mm bend radius (90° soft bend).
13 Do one of the following to extract customer data from the existing
system:
— If you are using a PC with the CCBR feature, skip this step and go
to Step 14 on page 25.
— If you are using the Database Upgrade Tool, install the software
cartridge from the existing system to the Database Upgrade Tool.
a Remove the software cartridge from the existing NTAK01
CPU/Conf or NTBK45 System Core card.
b Connect the Option 11 or Option 11E software cartridge to the
connector on the Database Upgrade Tool.
c Hold the Database Upgrade Tool with the software cartridge on
the left. Insert the Database Upgrade Tool in slot B of the
PCMCIA socket located in the faceplate of the NTDK20 SSC
card. See Figure 4 on page 25.
April 2000