Nortel Meridian 1 Option 11C Upgrade Manual page 135

Assign TDS/DTR, XTD, and SDI functions
10 Configure SDI ports 1 and 2 on the SSC card using LD 17 (shown
in Table 10).
Refer to the SDI printout you got in Step 1 on page 132.
Table 10
LD 17 - Configure SDI ports 1 and 2.
Prompt Response
REQ CHG
TYPE CFN
ADAN NEW TTY X
CDNO 0
PORT X
DES aaa...a
BPS 150, 300, 600, 1200,
2400, (4800), 9600,
19200
BITL 5, 6, 7, (8)
STOP (1), 1.5, 2
PARY ODD, EVEN, (NONE)
ENL (YES), NO
USER BUG, SCH, MTC
. . .
11 Enable the SDI ports in LD 37.
Use the commands "ENL TTY 1" and "ENL TTY 2."
12 Enable the TDS/DTRs on the SSC card using LD 34.
Use the "ENLX 0" command.
Option 11C and 11C Mini
Page 135 of 224
Comments
Change.
Configuration data block.
X = 1
X = 2
Card number 0
X= 1
X = 2
AML port identification (can be
up to 16 alphanumeric
characters)
Bits per second data rate
Data bit length
Number of stop bits
Parity
Auto enable SDI port
Upgrade Procedures Guide