Nortel Meridian 1 Option 11C Upgrade Manual page 101

Upgrade an Option 11E with fiber-optic cable to Option 11C
i
ii
• If you are using the Software Daughterboard, select
New System Installation or Option 11/11E Upgrade - From
Software Daughterboard.
c Select the feature set to be enabled from the "Select Feature Set
You Wish to Enable" menu.
Note: The items you select in steps c, d, f, g and h must match the one
provided with keycode data sheet.
d Select feature package numbers to add, if any.
Enter package numbers. Press <CR> twice to end package
selection.
e Select the database source.
Select one of the following from the "Select Option 11/11E
Database Source" list:
• Select CCBR Restore file if you extracted the customer
database using the CCBR feature. When you select this
option, you access the Data Transfer mode. You begin the
data restoration and upgrade process by pressing <CR> when
prompted to do so.
• Select Option 11/11E Software Cartridge if you are using the
Database Upgrade Tool to extract the customer database from
the existing software cartridge.
f Select the ISM parameters.
Compare the ISM parameters with those you printed in Step 3.
Make any required changes.
g Define the new AUX ID.
The default AUX ID is the security ID provided with the Option
11C. You must replace it with the previous Option 11 or Option
11E site ID.
h Confirm the information entered and enter the validation
keycodes.
Select System Upgrade from the Software Installation
Main Menu.
Select Option 11/11E to Option 11C
from the "Select type of upgrade to be performed" menu.
Option 11C and 11C Mini
Page 101 of 224
Upgrade Procedures Guide