Commands List - Ricoh CL7000 Operating Instructions Manual

D D D D
Exit telnet.
msh> logout
When the configuration is changed, a confirmation message appears asking you whether or not the
changes should be saved.
E E E E
Enter "yes" to save the changes, and then press { { { { Enter} } } } .
If you do not want to save the changes, enter "no", and then press { { { { Enter} } } } . If you want to make ad-
ditional changes, enter "return" at the command line, and then press { { { { Enter} } } } .
Note
If the "Can not write NVRAM information" message appears, the changes are not saved. Repeat
the steps above.
The network interface board is reset automatically when settings are changed.
When the network interface board is reset, active point jobs already sent will finish printing. How-
ever, jobs not yet sent are canceled.

Commands List

This is a list of commands that can be used via remote maintenance:
Note
Enter "help" to see a list of commands that can be used.
msh> help
Enter "help command_name" to display information about the syntax of that command.
msh> help command_name
Operating Instructions Administrator Reference
195