Ricoh CL7000 Operating Instructions Manual page 15

Configuring the printer
Configure the printer to use TCP/IP.
• Check TCP/IP is set to active. (The factory default is active.)
• Assign an IP address and make other settings required for TCP/IP.
Reference
For more information about how to make the above settings, see "Windows 2000 Configuration",
Printer Client Reference.
If DHCP is used to assign IP addresses, see
Note
After setting the IP address, use the ping command to confirm that it has been set correctly.
A
On the [Start] menu, point to [Programs], point to [Accessories] and then click [Command Prompt].
B
Enter the following: (Example: IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address is configured correctly, the following message appears:
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address is configured incorrectly, the following message appears:
Request timed out.
Configuring a Windows 2000 computer
Follow the procedure below to configure a Windows 2000 computer to use TCP/IP.
A A A A
On the [Start] menu, point to [Settings], and then click [Network and Dial-up Connections].
B B B B
Click [Local Area Connection]. On the [File] menu, click [Properties].
Operating Instructions
p.251 "Using
Administrator Reference
DHCP".
15