Ricoh CL7000 Operating Instructions Manual page 98

E E E E
Click [Property Sheet], and then click [OK].
TCP/IP
A Click the [General] tab, and then enter the device name in the [Device Name] box and com-
ment in the [Comment] box.
• In the [Device Name] box, enter the name of the printer using up to 13 characters. The factory
default name consists of "RNP" and the last 3 bytes of the MAC address on the network in-
terface board. For example, if the MAC address is 00:00:74:62:7D:D5, the factory default
name is "RNP627DD5". Nine character names are not permitted if the prefix is "RNP". Also,
if DHCP is selected as an IP address setting, the number of characters is limited to 13.
• In the [Comment] box, enter a printer comment using up to 31 characters.
NetBEUI
A Click the [General] tab, and then enter the comment in the [Comment] box.
In the [Comment] box, enter a printer comment using up to 31 characters.
B Click the [NetBEUI] tab.
C Enter the computer name in the [Computer Name] box.
• In the [Computer Name] box, enter a name to help identify the printers using NetBEUI. The
factory default name consists of "RNP" and the last 3 bytes of the MAC address on the net-
work interface board. For example, if the MAC address is 00:00:74:62:7D:D5, the factory de-
fault name is "RNP627DD5". A maximum of 13 characters consisting of uppercase
alphabetical letters, numbers, or symbols (except "*+,/:;<=>?[\]|. and space) can be used. No
name is permitted if the prefix is "RNP". You must avoid using same names on a network.
Operating Instructions Administrator Reference
98