Ricoh CL7000 Operating Instructions Manual page 35

Configuring the printer
Configure the printer to use TCP/IP.
• Check TCP/IP is set to active. (The factory default is active.)
• Assign an IP address and make other settings required for TCP/IP.
Reference
For more information about how to make the above settings, see "Windows XP Configuration", Print-
er Client Reference.
If DHCP is used to assign IP addresses, see
Note
After setting the IP address, use the ping command to confirm that it has been set correctly.
A
On the [Start] menu, point to [All Programs], point to [Accessories], and then click [Command
Prompt].
B
Enter the following: (Example: IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address is configured correctly, the following message appears:
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address is configured incorrectly, the following message appears:
Request timed out.
Operating Instructions
p.251 "Using
Administrator Reference
DHCP".
35