Ricoh CL7000 Operating Instructions Manual page 114

E E E E
Change names and comments.
TCP/IP
A Click the [General] tab, and then enter the name in the [Printer Name] box and comment in
the [Comment] box.
• In the [Printer Name] box, enter the name of the printer using up to 13 characters. The factory
default name consists of "RNP" and the last 3 bytes of the MAC address on the network in-
terface board. For example, if the MAC address is 00:00:74:62:7D:D5, the factory default
name is "RNP627DD5". Nine character names are not permitted if the prefix is "RNP". Also,
if DHCP is selected as an IP address setting, the number of characters is limited to using up
to 13.
• In the [Comment] box, enter a printer comment using up to 31 characters.
B Click the [IEEE 1394], and then enter the name in the [Device Name:] box when you change
the device name for IEEE 1394 (IP over 1394) interface.
• In the [Device Name:] box, enter the name of the printer using up to 13 characters. The factory
default name consists of "RNP" and the last 5 bytes of the EUI-64 on the IEEE 1394 (IP over
1394) interface. For example, if the EUI-64 is 00:00:74:00:02:01:0A:66, the factory default
name is "RNP0002010A66". 13 character names are not permitted if the prefix is "RNP".
Operating Instructions Administrator Reference
114