Ricoh CL7000 Operating Instructions Manual page 218

AutoNet
Use the "set" command to configure AutoNet.
Note
For more information about AutoNet, see
msh> set autonet {on|off}
Select "on" to activate AutoNet, and "off" to deactivate it.
Changing the Host Name
Use the "hostname" command to change the printer name.
msh> hostname [interface_name ] printer_name
Interface name
ether
*2
wlan
*3
ip1394
*1
If you did not enter the interface name, it will be automatically set to the Ethernet interface.
*2
If you install the optional 802.11b interface unit, you can set the command.
*3
If you install the optional 1394 interface unit, you can set the command.
Note
Enter the printer name using up to 13 characters.
You cannot use a printer name starting with "RNP" or "rnp".
The Ethernet interface and IEEE 802.11b interface will have the same printer name.
Operating Instructions
p.252 "Using
Interface to be configured
*1
Ethernet interface
IEEE 802.11b interface
IEEE 1394 interface
Administrator Reference
AutoNet".
218