Ricoh CL7000 Operating Instructions Manual page 209

Direct Printing Port
The direct printing port allows printing direct from a computer, connected to the network, to the printer.
Use the "diprint" command to change the direct printing port settings.
View settings
The following command displays the current direct printing port settings:
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect off
• The "Port" specifies the port number of the direct printing port.
• The "bidirect" setting indicates whether the direct printing port is bidirectional.
Setting timeout
You can specify the timeout interval to use when receiving data from the network.
msh> diprint [30~65535]
Note
The factory default is 300 seconds.
If 0 is set, timeout is disabled.
Bidirectional configuration for the direct printing port
Use this setting to configure whether the direct printing port is bidirectional.
The factory default is "off".
msh> diprint bidirect {on|off}
Operating Instructions Administrator Reference
209