ROUTE
Use the "route" command to control the routing table.
This command allows you to configure and display routing information. You can change the network
configuration from a remote computer using this command.
Note
The maximum number of routing tables are 16.
Parameter
route add {host | net} destination
gateway
route delete {host | net} destina-
tion
route get {destination}
route active {host | net} destina-
*1
tion
on/off
route add default gateway
route flush
*1
IP address
Operating Instructions
Topics of setting
Adds a host/network route to "destination", and a gateway address to "gateway"
in the table. Host becomes the default setting.
Deletes a host/network route from the table. Host becomes the default setting.
Displays only route information corresponding to a specified destination. When
the destination is unspecified, all routing information is displayed.
You can turn the specified destination on or off. Host becomes the default set-
ting.
*1
You can set the default gateway address.
Deletes all routing information.
Administrator Reference
212