Ricoh CL7000 Operating Instructions Manual page 213

SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the Pure IP environment of NetWare 5/5.1, 6. Using
the "slp" command, you can configure the value of TTL which can be used by SLP multi-cast-packet.
Note
The default value of TTL is "1". A search is executed only using up to a local segment. If the router
does not support multi-cast, the settings are not available even if the TTL value is increased.
The acceptable TTL value is 1 - 255.
msh> slp ttl {1 -255}
Setting IEEE 802.11b
To make setting for IEEE 802.11b, use the "wiconfig" command.
Limitation
You can make settings when installing the optional 802.11b interface unit.
View settings
The following command displays the current IEEE 802.11b settings:
msh> wiconfig
The IEEE 802.11b card information is displayed.
msh> wiconfig cardinfo
Note
If the IEEE 802.11b interface is not working correctly, IEEE 802.11b card information is not dis-
played.
Operating Instructions Administrator Reference
213