SNMP
Use the "snmp" command to display and edit SNMP configuration settings such as the community
name.
Note
You can configure the ten SNMP access settings numbered 1–10.
Default access settings 1 and 2 are as follows:
Number
Community name
IP address
Access type
Display
Displays SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Note
If the -p option is added, you can view the settings one by one.
Omitting the number displays all access settings.
Operating Instructions
1
2
public
admin
0.0.0.0
0.0.0.0
read-only
read-write
trap off
trap off
Administrator Reference
204