Ricoh CL7000 Operating Instructions Manual page 206

Access configuration
You can configure a host is address based on the protocols used.
The network interface board accepts requests only from hosts with addresses of access type "read-
only" or "read-write". Enter "0" to have network interface board accept requests from any host with-
out requiring a specific access type.
Command syntax:
msh> snmp number {ip | ipx} address
Note
To specify TCP/IP, enter "ip" followed by a space, and then the IP address.
To specify IPX/SPX, enter "ipx" followed by a space, then the IPX address followed by a decimal,
and then the MAC address of the network interface board.
The following is an example of how to configure registration number 3 with the IP address
192.168.15.16:
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with the IPX address
7390A448, and the MAC address 00:00:74:62:5C:65:
msh> snmp 3 ipx 7390A448:000074625C65
Operating Instructions Administrator Reference
206