BOMBARDIER Johnson 90 Service Manual page 42

PERIODIC MAINTENANCE
MAINTENANCE ANO TUNE-UP PROCEDURES
(3) Screw new filter on
by
hand until filter O-ring contacts
the mounting surface.
(4) Tighten filter 3/4 turn from point of contact with
mounting surface using an oíl filter wrench.
~ Engine oil filler: 14 N-m (1.4 kg-m; 10.0 lb-ft), 3/4
turn.
(5) lnstall STBD
síde
cover.
6. lnstall gasket and oíl draín plug. Tighten engine oíl drain
plug to specífied torque.
~ Engine oil drain plug: 13 N-m (1.3 kg-m; 9.5 lb--ft)
IACAUTION
1
Do not reuse gasket once removed. Always use a new
gasket.
7. Pour recommended engine oil into oíl filler opening, then
install oil filler cap.
Engine oil amounts
Oil change only: 5.5
1
(5.8 / 4.8 US / Imp. qt)
Oil filter change: 5.7
1
(6.0 / 5.0 US / Imp. qt)
8. Start engine and allow it to run for several minutes at idle
speed.
Check oil filter for oil leakage.
Turn off engine and wait for approx. two minutes, then
recheck engine oil level.
Low level
line
2-6