BOMBARDIER Johnson 90 Service Manual page 317

LOWER UNIT
ASSEMBLY ANO INSTALLATION- 90/115
Water Pump
1. Place dowel pins
G),
under panel gasket
®
and under
panel @ into position.
2. lnsert key @ in driveshaft and slide impeller @ onto
driveshaft, ensuring that key and keyway are aligned.
3. lnstall pump case @ while rotating driveshaft clockwise
to flex impeller vanes in correct direction.
4. Tighten tour pump case bolts to specified torque.
~ Pump case bolt: 20 N·m (2.0 kg-m; 14.5 lb-ft)
Propeller
1. lnstall spacer
G)
and propeller stopper
®
onto propeller
shaft, then slide on propeller @.
2. Fit spacer @, washer@ and nut @, then tighten nut to
specified torque.
~ Propeller nut: 55 N-m (5.5 kg-m; 40.0 lb-ft)
3. Push cotter pin ( ! ) through nut and shaft, then bend to
secure.
Lower Unit Assembly lnstallation
1. Apply Triple Guard Grease to clutch rod splines, then
install clutch rod
G)
by aligning clutch rod splines with
splines in clutch shaft.
•wlRG'~
Triple Guard Grease
9-29