BOMBARDIER Johnson 90 Service Manual page 294

LOWER UNIT
REMOVAL AND DISASSEMBLY -90/115
5. Remove clutch dog shifter
. I D
and connector pin
®)
from
propeller shaft.
Propeller Shaft Bearing Housing
NOTE:
lnspect bearings before removal, replace if necessary.
1 . Remove Propeller Shaft seal retaining ring and washer.
2. Remove seals usíng Puller Bridge, P/N 432127, and
Large Puller Jaws, P/N 432129. Discard seals.
l a
432127: Puller Bridge
432129: Puller Jaws
NOTE:
/nspect bearings in place. lf a bearing is removed for any
reason, it must be replaced.
3. Remove reverse gear bearing using Slide Hammer, P/N
432128, and Large Puller Jaws, P/N 432129.
1~'&il1
432128: Slide Harnmer
432129: Large Puller Jaws
4. Remove both propeller shaft bearings at the same time
using Bearing Remover P/N 351126.
1fciifü
351126: Bearing Remover
5. Discard bearing housing O-ring. Clean housing and bear­
ings in solvent and dry thoroughly. lf bearings were not
removed, rotate needles with your fingers to check for
freedom of movement. lnspect O-ring groove and sand
off any sharp edges that would cut O-ring.
9-6