MID UNIT
DAIVESHAFT HOUSING ANO OIL PAN
4. lnstall engine holder
(g,
to oil pan, then securely tighten it
with tour bolts @.
UPPER MOUNT
Upper mount and mount cover
1. Place washer
CD,
upper mount ~ and washer
@
on
upper mount bolt@.
2. Tighten upper mount rear nut @, pre-coated with thread
lock, to specified torque.
~ Nutlock
~
Upper mount rear nut:
80 N·m (8.0 kg-m; 58.0 lb-ft)
3. lnstall thrust mount @ to upper mount rear nut, then
place upper mount into engine holder.
4. lnstall upper mount covers
(?),
then tighten bolts
@,
pre
coated with thread lock, to specified torque.
NOTE:
Before tightening mount cover bolts, be sure upper mount
bolt head is positioned as shown in figure.
~ Nutlock
~
Upper mount cover plate bolt:
50 N-m (5.0 kg-m; 36.0 lb-ft)
5. lnstall clutch shaft holder® to engine holder, then tighten
bolts
®@
pre-coated with silicone seal, securely.
•Sise~ Silicone seal
7-10