POWER TRIM
ANO
TILT-140
DISASSEMBLY
Remove the PTT motor assembly. (See page 11-33) Note the
position of drive joint
®
and 0-ring @. before removing
them.
Remove the manual release valve snap ring @, then
unscrew the manual release valve @.
Remove the three (3) screws securing the PTT pump case
( ! ),
then detach the PTT pump case from PTT cylinder body.
Note the position of 0-rings and orífices collars, before
removing them.
A: Orífice collar (with ball valve)
B: Orífice collar (with filter and ball valve)
C: Orífice collar
Usíng special tool, unscrew the PTT cylínder head.
1- l oob
326485: PTT cylinder
cap
tool
8-34