Installation; Power Trim Ano Tilt - BOMBARDIER Johnson 90 Service Manual

POWER TRIM
ANO TILT - 90/115
INSTALLATION
INSTALLATION
tnstallation is reverse arder of removal with special attention
to the following steps.
1. Lower tilt rod to full down position.
2. Apply Triple Guard Grease to tilt cylinder lower shaft and
lower shaft bushes.
3. lnstall bushings
G)
and cylinder lower shaft
(2)
to PTT
unit.
llwiRG's]
Triple Guard Grease
4. Place PTT unit in position, then install clamp bracket.
5. Tíghten clamp bracket shaft nut to specified torque.
~ Clamp bracket shaft nut:
43 N-m (4.3 kg-m; 31.0 lb-ft)
6. Tighten lower shaft bolts @, pre-coated with thread lock,
to specified torque.
~ Nutlock
~ Cylinder lower shaft bolt:
50 N-m (5.0 kg-m; 36.0 lb·ft)
7. lnstall anode @, then tighten bolts securely.
8-22