BOMBARDIER Johnson 90 Service Manual page 393

WIRE / HOSE ROUTING
FUEUWATER HOSE ROUTING
FUEUWATER HOSE ROUTING
I
. A
CAUTION
1
• Do not over-bend (kink) or twist hoses when installing.
• When installing hose clips, position tabs to avoid contact with other parts.
• Check that hoses do not contact rods and levers during either engine operation or standstill.
• Extreme care should be taken not to cut, abrade or cause any other damage on hoses.
• Care should be taken not to cause hoses to be compressed excessively by any clamp when fit­
ted.
Fuel hose / Protector
(3-way joint to Fuel delivery pipe)
Fuelhose
(Low pressure fuel pump
to Fuel vapor separator)
Evaporation hose (Fuel vapor separator to Cylinder head cover)
Clamp : Fix fuel house and water hose.
High pressure fuel filler
~<
1 ' W .L.L·,c. O 'T'" ,_ ¡ . . , ¡ ; ; ,.,..,t. , . . :.----_U_<
<
Water hose
to Water retum pipe /
Water hose
from Fuel return pipe
from 3-way joint
G)
High pressure fuel filler-
- to Fuel delivery pipe
\ from low pressure fuel pump
3-way joint @
Water hose
llffftl
(lntake manifold
to 3-way joint @)
Fuel vapor separator
Water hose (3-way joint G) to Fuel return pipe)
to Pilo! water tube
Water hose
(3-way joint
<í)
to lntake manifold)
to Crankcase lower
from Engine holder
Fuel hose / Protector
(Fuel return pipe to Fuel vapor separator)
3-way joint
<í)
10-8