LOWER UNIT
ASSEMBLY AND INSTALLATION-140 (COUNTER ROTATION)
Pinion Bearing
IACAUTION
1
Before installing bearing, ensure that inside of gearcase
Is clean and free of debris.
1. Assemble the following components of Universal Pinion
Bearing Remover and lnstaller kit, P/N 391257.
G)
1/4 - 20 x 1/2 in Hex Head Screw
(2)
1 in O.O. Flat Washer
@ 341437: Spacer
@ 391260: Bearing and Plate
@ 326582: Rod
@ 326574: Remover/lnstaller
( J )
1/4 - 20 x 1 1/2 in Hex Head Screw
2. Place bearing on installer tool with lettered side of bear
ing facing tool. Use Needle Bearing Assembly Grease to
hold bearing on tool.
3. lnsert tool and bearing into gearcase. Using a rawhide
mallet, drive bearing into gearcase until washer
(2)
con
tacts spacer @.
¡=¡
G)
--@
®--
9-80