BOMBARDIER Johnson 90 Service Manual page 370

LOWER UNIT
ASSEMBLY ANO INSTALLATION-140 (COUNTER ROTATION)
Driveshaft
1. Assemble washer
G),
washer (with tab) ~. wave washer
®,
washer@ and driveshaft collar@ to driveshaft.
2. After installing driveshaft collar, fit convex part of collar in
concave part of driveshaft by turning collar.
3. Lower driveshaft assembly @ down into gearcase until
bottom of shaft protrudes through center of pinion.
NOTE:
Washer tab should be located into groove on gearcase.
4. lnstall bearing outer race
( ! )
and pinion shim @ to drive­
shaft.
Driveshaft Oíl Seal Housing
1. Apply Triple Guard Grease to driveshaft oil seal.
~ Triple Guard Grease
2. Apply Triple-Guard Grease to O-ring, then install O-ring
into groove on driveshaft oil seal housing.
3. Instan driveshaft oil seal housing on gearcase, then
tighten four bolts to specified torque.
~ Driveshaft oil seal housing bolts: 20 N·m
(2.0 kg-m; 14.5 lb-ft)
9-82