BOMBARDIER Johnson 90 Service Manual page 170

POWER UNIT
OIL PUMP
lnstallation
lnstallation is reverse order of removal with special attention
to the following steps.
• Assemble washer G), pin
(2),
driven sprocket@ and circlip
@ to oil pump shaft.
• Apply engine oil to seal ring @, then install seal ring to oil
pump body.
IACAUTION
1
Do not reuse seal ring once removed. Always use a new
seal ring.
• lnstall oíl pump @ to cylinder head block, then tighten
three (3) bolts securely.
• lnstall oil pump
dríve
sprocket
( ! )
and tighten bolt securely.
~ Oil pump drive sprocket bolt:
78 N-m (7.8 kg-m; 56.5 lb-ft)
____J
6-16