POWER UNIT
CYLINDER HEAD ASSEMBLY
NOTE:
Befare installing camshafts, turn crankshaft until No. 1 cylin
der reaches top dead center. (See page 6-17)
NOTE:
When installing camshaft, adjust relative position between
sprockets and chain so match marks (dot) on timing sprock
ets are as shown in figure and engraved fines on sprockets
align with cylinder head cover mating tace.
7. lnstall camshaft housing pins as shown in figure.
8. Check position of camshaft housing.
NOTE:
Embossed marks are provided on each camshaft housing
indicating position and direction of installation.
9. lnstall housings as indicated by these marks.
1. Match rnark (•)
2. Match mark (engraved line)
3. Cylinder head cover mating lace
Pin
1:
lntake side
E: Exhaust side
Position from flywheel
magneto side
Pointing to flywheel
magneto side
6-25