Table of Contents
Advertisement
Table B-1
the Quick-Start procedure.
Filling Out the Quick-Start Sample Worksheets
The inst_pp5400.bat script provides many options for configuring the Passport
5430 on a network. Because the Passport 5430 uses a serial interface over a wide
area connection, this sample describes only the options involved with a serial
configuration.
Note: This section provides worksheets only for a serial interface
configuration over a wide area connection. It does not contain worksheets for
LAN configuration options. If you are configuring a LAN interface, read the
Quick-Start text and prompts carefully before responding.
Nortel Networks recommends that you follow this procedure when you fill out the
worksheets:
1.
2.
306308-A Rev 00
provides the connector names and numbers that you should use during
Table B-1.
Quick-Start Connector Names and Numbers
System
Interface*
Processor Expansion
Dual
XCVR1
Ethernet
XCVR2
ATM T1/E1
ATM1
Dual
N/A
synchronous
FT1/T1, or
N/A
FE1/E1
DSU/CSU
* The Quick-Start script does not support initial ISDN or V.34 interface configuration.
Fill out the Global Information worksheet completely.
The sample worksheet lists options common to all serial interface
configurations.
After you record your protocol selections on the Global Information
worksheet, fill out one Router Protocol worksheet.
Worksheets for the Quick-Start Procedure
Module
WAN
Adapter 3
N/A
N/A
N/A
N/A
PORT1,
N/A
PORT2
N/A
COM1
WAN
WAN
Adapter 4
Adapter 5
N/A
N/A
N/A
N/A
N/A
N/A
COM1
COM1
B-3
Advertisement
Table of Contents
