BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 74

F04D0CA
Install gasket no. 8 between magneto housing
and engine crankcase.
Install magneto housing and torque screws no. 9
to 9 N•m (80 lbf•in).
4,5, Rotor and Flywheel
When reinstalling magneto rotor to engine fly-
wheel, apply Loctite 648 to mating surfaces.
One of the protusion end of magneto rotor must
align with hole of engine flywheel.
1 1
F01D83A
1. Protusion
2. Hole
Apply Loctite 648 (green) on screws no. 11 and
torque to 10 N•m (88 lbf•in).
Apply Loctite 242 (blue) on crankshaft taper.
2
Subsection 04 (MAGNETO SYSTEM)
Apply Loctite 242 (blue) on nut no. 6. Install nut
with lock washer and torque to 105 N•m (77 lbf•ft).
-
CAUTION
Never use any type of impact wrench at mag-
neto installation.
1, Cover
Before installation, properly install O-ring no. 3 in
engine magneto cover.
Apply Loctite 767 anti-seize compound on screws
no. 2. Torque screws in a criss-cross sequence to
9 N•m (80 lbf•in).
947 Engine
8,9, Stator and Trigger Coil
Install the stator and trigger coil in engine magne-
to cover. Torque screws to 9 N•m (80 lbf•in).
Reinstall wiring harness bracket no. 12 using tap-
tite screws no. 13.
Torque trigger coil screws no. 11 to 9 N•m (80 lbf•in).
Torque stator screws no. 10 to 13 N•m (115 lbf•in).
NOTE: The trigger coil is not adjustable.
1 2
F06D0NB
1. Torque to 9 N•m (80 lbf•in)
2. Taptite screws
3. Torque to 13 N•m (115 lbf•in)
Section 04 ENGINE
3
04-04-13