BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 73

Section 04 ENGINE
Subsection 04 (MAGNETO SYSTEM)
-
CAUTION
Never use any type of impact wrench at mag-
neto installation.
Ignition Timing
For ignition timing procedures of the 717 engine,
refer to IGNITION SYSTEM 08-02.
1, Magneto Housing Cover
Properly install O-ring no. 3 in magneto housing.
Apply Loctite 767 anti-seize on screws no. 2, install
cover and wire support no. 17. Torque screws no. 2
in a criss-cross sequence to 9 N•m (80 lbf•in).
787 Engine
12, Stator
Install the stator in magneto housing cover no. 1
and torque screws no. 13 to 10 N•m (88 lbf•in).
Replace wiring harness bracket no. 16 of stator
and torque screws to 4.5 N•m (40 lbf•in).
1
F06D0CA
1. Stator screws
2. Bracket
14, Trigger Coil
Install the trigger coil in magneto housing cover
no. 1 and torque screws no. 15 to 10 N•m (88 lbf•in).
NOTE: The trigger coil is not adjustable.
04-04-12
2
F06D0DA
1. Trigger coil
7, Magneto Housing
To install oil seal no. 10 of magneto housing, use
pusher (P/N 290 877 740) and handle (P/N 290
877 650).
1
F01B2NA
1. Pusher
2. Handle
1
2