BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 131

8, Bearing
To remove bearing use a bearing extractor such as
Snap-on no CJ-950 as illustrated. Slide off dis-
tance sleeve, remove snap ring no. 7 and press
shaft out.
F01D4NA
1. Bearing
2. Bearing extractor Snap-on CJ-950
-
CAUTION
Ensure that rotary valve shaft is perfectly
perpendicular with press tip.
9, Bearing
-
CAUTION
Do not remove plug against bearing in up-
per crankcase half.
F01D4OA
1. Do not remove this plug
End bearing can be easily removed using the fol-
lowing suggested tool.
1
2
1
Subsection 07 (ROTARY VALVE)
Snap-on hammer puller including:
Handle CJ93-1
Hammer CJ125-6
Claws CJ93-4
F01J0ZA
Close puller claws so that they can be inserted in
end bearing. Holding claws, turn puller shaft clock-
wise so that claws open and become firmly tight
against bearing.
Slide puller sleeve outwards and tap puller end.
Retighten claws as necessary to always maintain
them tight against bearing. Continue this way un-
til bearing completely comes out.
1
F01D28A
1. End bearing
CLEANING
Discard all seals and O-rings.
Clean all metal components in a solvent.
Clean oil passages and make sure they are not
clogged.
Clean rotary valve shaft and inside of distance
sleeve no. 14.
Section 04 ENGINE
04-07-5