BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 272

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
Rotate impeller remover tool counterclockwise
and unscrew completely impeller.
-
CAUTION
Never use any impact wrench to loosen im-
peller.
To remove impeller, apply a rotating movement
and pull at same time. Slide impeller out of hous-
ing. Remove tool from impeller.
21, Wear Ring
Place jet pump housing in a vise with soft jaws. It
is best to clamp housing using a lower ear.
Cut wear ring at two places.
NOTE: Wear ring can be cut using a jigsaw, a small
grinder or a low clearance hacksaw such as Snap-
on HS3 or equivalent.
-
CAUTION
When cutting ring, be careful not to damage
jet pump housing.
F01J0VA
TYPICAL
09-02-8
F01J0WA
TYPICAL
1. Snap-on HS3
After cutting ring, insert a screwdriver blade be-
tween jet pump housing and ring outside diameter.
Push ring so that it can collapse internally.
Pull ring out.
24, Impeller Shaft
Remove shaft holder tool.
Remove impeller shaft with thrust washer and
thrust bearing.
22,23, Seal and Needle Bearing
Remove seal and bearings at the same time using
bearing/seal remover tool (P/N 295 000 144).
F01J11A
Insert bearing remover then press tool using a ar-
bor press until seal and bearings are out. However,
care should be taken not to damage bearing jour-
nals.
1