BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 404

-
CAUTION
Do not pierce the diaphragm with a sharp
point for electrical troubleshooting. The re-
sulting pinholes in the insulation will allow
moisture to penetrate the system and possi-
bly result in system failure.
Contact Installation
For insertion of signal contact, make sure the
wedge lock is in the open position.
NOTE: For insertion of power contact, the wedge
lock may or may not be on the open position.
Insert contact into appropriate circuit cavity and
push as far as it will go.
Pull back on the contact wire to be sure the reten-
tion fingers in the housing are holding the contact
properly.
After all required contacts have been inserted, the
wedge lock must be closed to its locked position.
Section 14 WIRING DIAGRAMS
Subsection 01 (WIRING DIAGRAMS)
14-01-5