BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 101

Section 04 ENGINE
Subsection 05 (TOP END)
787 Engine
The exhaust manifold is used to align cylinders.
F00D0FA
787 ENGINE
1. Aligning cylinders using exhaust manifold
9, Cylinder Block
947 Engine
Install studs no. 32. Apply Loctite 242 to threads
and torque studs to 5 N•m (44 lbf•in).
Install cylinder base gasket no. 10. There is only
one way to install gasket.
The cylinder block is positioned with locating dow-
els.
1
F06D1PA
1. Dowel
To easily slide cylinder block over pistons, use ring
compressor (P/N 290 876 965).
04-05-26
1
A01B1TA
1. Slide this edge
NOTE: For each ring, make sure to align ring end
gap with piston locating pin.
Install cylinder block.
Install O-rings no. 31.
-
CAUTION
The O-rings must be installed and properly po-
sitioned in the cylinder block. The O-rings are
meant to dampen stud vibration.
13, Cylinder Screw
717 Engine
Apply synthetic grease below the screw head.
Apply also Loctite 242 (blue) on screw threads.
Install and torque screws in a criss-cross sequence
for each cylinder to 24 N•m (17 lbf•ft). Refer to the
following illustration.
1
3
F01D35A
1
4 1
2 3
4
2