BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 280

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
Apply Loctite 271 (red) to shaft threads.
1
F00J0GA
1. Apply Loctite 271 (red) on threads
Using 2 screws previously removed from venturi,
secure impeller shaft holder tool to housing.
Install shaft holder tool in a vice.
1
F00J0HA
1. Impeller shaft holder secured in a vice
To ease impeller installation, apply BOMBARDIER
LUBE lubricant on wear ring.
Insert impeller into wear ring. Manually rotate im-
peller and push so that it slides on impeller shaft
threads. Carefully engage threads making sure
they are well aligned.
Install impeller remover/installer tool into impeller
splines and tighten.
09-02-16
F00J08A
1. Impeller remover/installer tool
-
CAUTION
Make sure thrust washer and bearing are
not wedged in shaft groove. To check, manu-
ally pull and push jet pump housing, some
axial play must be felt.
Torque impeller to 70 N•m (52 lbf•ft) then remove
tools.
-
CAUTION
Never use any impact wrench to tighten im-
peller.
Apply synthetic grease (P/N 293 550 010) on im-
peller splines.
Insert a new boot no. 15 and ring no. 16 to impel-
ler.
1
F00J0IA
1. Boot and ring
1