BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 277

2
1
F01J5EA
1. Piece of wood
2. Seal lip facing upward
3. Wear ring
22,23, Seal and Needle Bearing
Bearings and seal will be properly installed in
housing using bearing/seal installer tool (P/N 295
000 107).
1
F01J4KA
BEARING/SEAL INSTALLER TOOL
1. Seal side
2. Bearing side
Stamped end of bearings (showing identification
markings) must be located toward outside of hous-
ing.
Properly insert bearing on tool. Using an arbor
press only, push tool until tool flange contacts
housing. Proceed the same way for both bearings.
3
2
Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
1
F01J1HA
1. Stamped end this side
-
CAUTION
Never hammer the bearing into its housing.
1
F00J0BA
1. Press on tool until it stops
-
CAUTION
This tool have been designed to properly po-
sition bearings and seal, thus providing
space for lubrication purposes. The tool
flanges allow this. If a different pusher type
is being used, components must be properly
positioned as follows.
09-02-13