BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 190

Throttle Cable
Lubricate cable with BOMBARDIER LUBE lubri-
cant.
Throttle lever must reach handlebar grip without
causing strain to cable or carburetor cable bracket.
F01K08A
1. Must touch handlebar grip
Ensure carburetor throttle plate(s) is (are) fully open
at full throttle position. At this position, throttle le-
ver stopper is almost in contact (0.5 mm (1/64 in))
with carburetor body.
NOTE: Apply a light pressure on the throttle plate(s),
a slight play should be obtained.
-
CAUTION
Improper cable adjustment will cause strain
on cable and/or damage cable bracket or
throttle lever at handlebar.
To adjust, loosen jam nut then turn adjustment nut
as necessary.
3 1
F01G0YC
717 ENGINE
1. Adjustment nut
2. Jam nut
3. Throttle lever stopper
1
2
Section 06 FUEL SYSTEM
Subsection 04 (CARBURETOR)
F01F32B
787 ENGINE
1. Throttle lever stoppers (behind levers)
2. Adjustment nut
F06F0FA
947 ENGINE
1. Throttle cable
2. Adjustment nut
Tighten jam nut and recheck adjustment.
WARNING
Make sure idle speed screw contacts stopper
when throttle lever is fully released at han-
dlebar.
After throttle cable adjustment, always proceed
with the oil injection pump cable adjustment. Re-
fer to OIL INJECTION PUMP 07-03.
-
CAUTION
Improper oil injection pump synchronization
with carburetor can cause serious engine
damage.
1
2
2 1
06-04-9