BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 61

Engine Support Screws
Apply Loctite 242 (blue) on screw threads.
Torque engine support screws to 25 N•m (18 lbf•ft)
when procedure is completed.
Loctite
242
1
1
Loctite
242
F02D0KA
717 ENGINE
1. Torque to 25 N•m (18 lbf•ft)
1
F06D35A
FRONT ENGINE SUPPORT — 787 AND 947 ENGINES
1. Torque to 25 N•m (18 lbf•ft)
Subsection 03 (REMOVAL AND INSTALLATION)
Loctite
242
1
F06D36A
REAR ENGINE SUPPORT — 787 AND 947 ENGINES
1. Torque to 25 N•m (18 lbf•ft)
Final Inspection
Check throttle cable condition and lubricate cable
with BOMBARDIER LUBE lubricant.
After its installation, properly adjust and bleed oil
injection pump as specified in OIL INJECTION
PUMP 07-03.
Check hose condition and pressure test fuel sys-
tem, refer to FUEL CIRCUIT 06-02.
Whenever doing any type of repair on water-
craft or if any components of the fuel system
are disconnected, a pressure test must be
done before starting engine.
Verify all electrical connections.
Run engine and ensure there is no leakage.
If watercraft is out of water, engine must be
cooled using the flush kit.
Section 04 ENGINE
1
;
WARNING
-
CAUTION
04-03-7