BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 59

Engine Support
717 Engine
Torque front and rear engine supports as shown in
the following illustration.
Loctite
242
1
F02D09A
1. Torque screws to 22 N•m (16 lbf•ft)
2. Torque nuts to 39 N•m (29 lbf•ft)
787 and 947 Engines
Apply Loctite 242 (blue) to rear engine support
screws and torque to 24 N•m (17 lbf•ft).
1
F06D36C
1. Torque engine support screws to 24 N•m (17 lbf•ft)
Oil Injection Hoses
717 and 787 Engines
Make sure to reinstall hoses before completely
lowering engine in bilge.
Subsection 03 (REMOVAL AND INSTALLATION)
Loctite
1
242
Loctite
2
242
Positive Starter Cable
Torque nut of positive starter cable to 6 N•m
(53 lbf•in). Apply dielectric grease on nut.
Engine/Jet Pump Alignment
Alignment is necessary to eliminate possible vi-
bration and/or damage to components. Check
alignment of engine using the following alignment
tools.
Support plate kit (P/N 529 035 506).
NOTE: Use plate (P/N 529 035 508) for the 139.5 mm
(5-1/2 in) jet pump and plate (P/N 529 035 507) for
the 155.6 mm (6-1/8 in) jet pump.
1 2
F00B0FA
1. Plate (P/N 529 035 507 or 529 035 508)
2. Support (P/N 529 035 511)
Alignment shaft (P/N 295 000 141).
F00B0GA
1. Alignment shaft
Section 04 ENGINE
1
04-03-5