BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 284

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
SPX and GTS Models
Secure water supply hose and both bailer tubes to
jet pump housing using tie raps.
F01J0IA
1. Bailer tubes
2. Water supply hose
Reinstall air vent tube support onto body (SPX model).
5, Nozzle
GS, GTS, GTI and GTX Limited
Insert bushings no. 3 in nozzle no. 5, positioning
their flanges from inside of nozzle.
Insert sleeves no. 2 in bushings no. 3.
Install nozzle no. 5 on venturi no. 11; position its
steering arm on RH side. Apply Loctite 242 (blue)
on screw threads (or use new screws with pre-
applied threadlocker). Install screws no. 1 and lock-
ing disks no. 4 then torque to 20 N•m (15 lbf•ft).
1
1
F01J3BA
TYPICAL
1. Locking disks
2. Torque screws to 20 N•m (15 lbf•ft)
09-02-20
Whenever removing screw always renew
locking disks. Screw must be torqued as spec-
1
ified.
SPX, GSX Limited, and XP Limited
Install nozzle/trim ring assembly.
Torque screws to 14 N•m (10 lbf•ft).
NOTE: Trim ring has a tight fit; to install, insert
both sides at the same time, taking care not to
break plastic bushings. Carefully use a plastic tip
hammer if necessary. Make sure steering arm of
2
jet pump is on right side and trim arm is above
venturi.
F01J5FA
1. Torque screws to 14 N•m (10 lbf•ft)
Steering Cable
Refer to section 10, STEERING SYSTEM.
Trim System
Refer to VARIABLE TRIM SYSTEM 09-05.
Reverse Cable
Refer to REVERSE SYSTEM 09-04.
2
WARNING
1