BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 304

Section 09 PROPULSION SYSTEM
Subsection 04 (REVERSE SYSTEM)
-
CAUTION
Always hook reverse gate springs in order to
ease reverse gate operation.
F02J02B
1. Screws, washers and sleeves
6, Reverse Support
For reverse support installation, torque screw to
8 N•m (71 lbf•in) and Allen screws to 2 N•m
(18 lbf•in).
4,5, Triangular Lever and Sliding Block
Insert bushing in triangular lever and then install
lever to reverse support.
F02J0CA
TYPICAL
1. Bushing
Install reverse cable to triangular lever with bush-
ing, plastic washer(s) and flat washers.
Torque cable screw to 7 N•m (62 lbf•in).
09-04-4
1
1
Torque triangular lever screw to 8 N•m (71 lbf•in).
Install sliding block to lever and torque nut to
8 N•m (71 lbf•in).
1,5, Locking Lever and Sliding Block
Insert locking lever end in support hole then align
lever and sliding block holes.
F02J0DA
TYPICAL
1. Support hole
3, Shift Lever
NOTE: Always install shift lever with its open end
facing left side of watercraft, then push shift lever
stem through locking lever no. 1 and sliding block
no. 5 holes.
1
F02J0EA
TYPICAL
1. Install shift lever as shown
1