BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 271

All Models
18, Cover
With pump assembly in horizontal position, remove
3 retaining screws no. 19.
Place container under cover to catch oil.
Using a fiber hammer, gently tap cover to release
it from jet pump housing.
20, Impeller
Insert impeller shaft holder (P/N 295 000 082) on
impeller shaft flat end.
Using 2 screws previously removed from venturi,
secure shaft holder to housing.
1
F00J07A
1. Shaft holder
Heat impeller center with a propane torch to ap-
proximately 150°C (300°F) to break the Loctite
bond.
Install shaft holder in a vice.
Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
1
F00J0HA
1. Shaft holder
Impeller is loosened using impeller remover tool
(P/N 295 000 001).
F01J0TA
Insert special tool in impeller splines.
F00J08A
1. Impeller remover tool
1
09-02-7