BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 278

Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
Bearing on impeller side must be 1.5 to 2.5 mm
(.060 - .100 in) inside reservoir measured from
seal seat. Bearing on venturi side must be 2 to
3 mm (.080 - .120 in) inside reservoir measured
from thrust washer seat. Refer to following illus-
tration.
A
1
2
F01J1JA
1. Seal seat
2. Stamped end of bearing
3. Thrust washer seat
4. Stamped end of bearing
A. 1.5 - 2.5 mm (.060 - .100 in)
B. 2 - 3 mm (.080 - .120 in)
Seal must be installed so that lips raised edges
are toward outside of housing (toward impeller).
Apply Loctite 518 (P/N 293 800 038) to seal hous-
ing, all around outer diameter and on seal seat.
Properly insert seal on tool.
NOTE: It is important when installing seals to
pack seal lip with grease before inserting bear-
ing/seal installer tool. Properly insert tool in seal
with a rotating movement.
1
F01J1KA
1. Raised edge of seal this side
09-02-14
Prevent sealant from contacting any needles
of bearing.
Push on tool end with a press until tool flange con-
tacts housing.
B
3
4
F00J0CA
1. Press on tool until it stops
Apply synthetic grease (P/N 293 550 010) between
seal lips.
F01J1MA
1. Loctite 518 all around and behind
2. Raised edge of seal lip this side
-
CAUTION
1
1
2