BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 281

18, Cover
Install O-ring no. 27 to cover. Apply Loctite 518 on
O-ring. Make sure spring and anti-knock pusher
are in place.
3
F00J0PA
1. Spring
2. Pusher
3. O-ring with Loctite 518
Install cover to jet pump housing making sure to
properly position filler plug on top side.
F01J5IA
1. Filler plug toward top side of pump housing
Apply Loctite 242 (blue) on screw threads and
evenly tighten cover screws. Torque to 4 N•m (35
lbf•in).
Oil Fill
NOTE: It is highly recommended to perform a leak-
age test prior adding the oil. See PUMP PRESSUR-
IZATION in this subsection.
2 1
1
Section 09 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
Place housing horizontally as in its operating posi-
tion so that filler plug is located on top. Remove
filler plug from cover. Pour SEA-DOO JET PUMP
SYNTHETIC OIL (P/N 293 600 011) in reservoir un-
til oil comes level with bottom of hole. Let oil drain
into housing and after a few minutes add more oil
until it is level with bottom of filler hole.
-
CAUTION
This is a synthetic oil. Do not mix with min-
eral based oil. Do not mix oil brands.
NOTE: When filling reservoir, oil must be poured
into cover quite slowly to allow complete housing
fill.
F00J0JA
TYPICAL
1. Pour oil slowly until it is level with bottom of filler hole
11, Venturi
If needed, install new O-rings no. 10 around bailer
passages.
F00J0KA
1. O-rings
1
1
09-02-17