BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 402

1
F00H0OA
1. Screwdriver between wedge lock and connector
2. Locking tab
Repeat the same steps for the other locking tab
retaining the wedge lock.
The wedge lock is now in the open position.
1
F00H0PA
1. Wedge lock opened
While rotating the wire back and forth over a half
turn (1/4 turn in each direction), gently pull the
wire until the contact is removed.
2
1. Rotate wire back and forth
2. Pull wire
POWER WIRE CONTACT
NOTE: The wedge lock must be removed to ex-
tract power contact.
Open the wedge lock.
Pull both locking tabs and remove wedge lock
from plug assembly.
1. Pull locking tab (both sides)
Before extraction, push wire forward to relieve
pressure on retaining tab.
Insert a 4.8 mm (.189 in) wide screwdriver blade
inside the front of the contact cavity.
Section 14 WIRING DIAGRAMS
Subsection 01 (WIRING DIAGRAMS)
1
2
F00H0QA
1
F00H0RA
14-01-3