Section 08 ELECTRICAL SYSTEM
Subsection 02 (IGNITION SYSTEM)
3. Start engine and point timing light straight in
line with timing tool slot. Bring engine to 6000
RPM.
1
F00H0IA
1. Timing light straight in line with tool slot
-
CAUTION
If engine is to be run more than a few sec-
onds, engine must be cooled using the flush
kit.
4. Check if PTO flywheel mark aligns with timing
tool slot.
NOTE: On this system, timing advance decreas-
es as engine speed increases.
If timing mark aligns with tool slot, timing is prop-
erly set. If mark does not align with tool slot, re-
check PTO flywheel mark before adjusting igni-
tion timing to ensure PTO flywheel has not loosen.
08-02-8
787 and 947 Engines
1. Connect an induction-type tachometer (P/N
295 000 100) to spark plug wire.
1
F06H06A
1. Tachometer pick-up
2. Connect timing light pick-up to MAG side spark
plug wire.
1
F00H0HA
1. Timing light pick-up
3. Rev the engine to 3500 RPM and point beam of
timing light straight in line with timing mark
pointer.