BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 102

787 Engine
Prior installation, apply synthetic grease below
screw head and Loctite 518 on screw threads.
Install M10 x 105 screws on exhaust side and the
M10 x 73.5 on opposite side.
Torque screws in a criss-cross sequence for each
cylinder to 20 N•m (15 lbf•ft). Repeat the proce-
dure, retightening all cylinder screws to 40 N•m
(30 lbf•ft).
2 3
4 1
F01D7FA
2, Cylinder Head
717 and 787 Engines
Make sure to install O-rings no. 12 around spark
plug holes and O-ring no. 11 of cylinder head as
shown in the following illustration.
1
F01D5AA
1. O-rings
3 2
1 4
1
Subsection 05 (TOP END)
Apply Loctite 518 in O-ring groove of cylinder
sleeves.
Install cylinder head.
947 Engine
Apply Loctite 242 (blue) on the threads of the cyl-
inder block studs no. 32.
Apply Loctite 242 (blue) below head of cylinder
head bolts no. 14.
Apply synthetic grease on threads of cylinder
head bolts no. 14.
Torque bolts and nuts to 15 N•m (11 lbf•ft) as per
following sequence in the next picture. Repeat
the torquing sequence by retightening to 34 N•m
(25 lbf•ft).
7 12 1 10
13 4 9
F06D0WB
TORQUING SEQUENCE
1, Cylinder Head Cover
717 and 787 Engines
Install cylinder head cover.
Apply Loctite 242 (blue) below head of screws
no. 14.
Apply also synthetic grease on threads of screws
no. 14.
Torque cylinder head screws no. 14 to 12 N•m
(9 lbf•ft) as per following illustrated sequence.
Repeat the procedure, retightening all screws to
24 N•m (17 lbf•ft).
Section 04 ENGINE
8 3 14
5 11 2 15
04-05-27
6