BOMBARDIER SEA-DOO SPX 5838 1998 Shop Manual page 207

Section 07 LUBRICATION SYSTEM
Subsection 03 (OIL INJECTION PUMP)
787 Engine
NOTE: The adjustment nut and jam nut for the oil
injection pump cable are located at the cable sup-
port on PTO side carburetor.
1 2
F01F32G
1. Adjustment nut on this side
2. Jam nut
947 Engine
NOTE: The adjustment nut and jam nut for the oil
injection pump cable are located at the cable sup-
port on MAG side carburetor.
1
F06F0OB
1. Adjustment nut
All Engines
Start and bring engine to normal operating tem-
perature.
-
CAUTION
If watercraft is out of water, engine must be
cooled using the flush kit. If air bubbles are
present in the oil injection system, bleed
system before operating engine.
07-03-6
Adjust idle speed to specification. Refer to CAR-
BURETOR 06-04.
Stop engine.
Final Synchronization
Eliminate throttle cable free-play by depressing
throttle lever until a slight resistance is felt. In this
position, marks on pump body and lever must
align.
NOTE: A mirror may be used to facilitate this ver-
ification.
If necessary, turn cable adjustment nut to obtain
pump mark alignment. Refer to above illustra-
tions.
Tighten jam nut and recheck alignment marks.
-
CAUTION
Proper oil injection pump adjustment is very
important. Any delay in the opening of
pump can result in serious engine damage.
Bleeding
-
CAUTION
Oil injection system must be bled and ad-
justment checked before operating engine.
Ensure oil injection reservoir is sufficiently filled.
Install a dry rag below oil injection pump.
Loosen bleed screw to allow oil to flow.
F01D4SC
717 ENGINE
1. Bleed screw
1